Splined Shafts


SPLINED SHAFTING is hobbed for the full listed length. In some instances undercut chucking registers may be present at one end. A centre is provided at one end. Material is K1045 Carbon steel. Finish is black "Colorsol". Imperial involute splines are to ANSI B92.I-1970. Pressure angles on all involute splines listed are 30 degrees. Spline OD* as listed for shafting, stubwelds and nibs is the form diameter. Actual major diameter may be smaller than form diameter by the form clearance for the subject spline. Straight sided splines are all to SAE standard.
 
Part # Description Nom dia Standard No. of Teeth
94/70001SHAFT 9T 5/8" 16/32 6" Long 5/8"16/32 DP INV CL59
94/70002SHAFT 11T 3/4" 16/32 6" Long 3/4"16/32 DP INV CL5 11
94/70003SHAFT 13T 7/8" 16/32 6" Long 7/8"16/32 DP INV CL5 13
94/70004SHAFT 15T 1" 16/32 8" Long 1"16/32 DP INV CL5 15
94/70005SHAFT 6T 1" Straight 10" Long 1"6B STRAIGHT SAE 6
94/70005SSHAFT 6T 1" Straight 8" Long 1"6B STRAIGHT SAE 6
94/70006SHAFT 14T 1 1/4" 12/24 8" Long1 1/4"12/24 DP INV CL5 14
94/70007SHAFT 21T 1 3/8" 16/32 8" Long1 3/8"16/32 DP INV CL5 21
94/70008SHAFT 13T 1 3/4" 8/16 8" Long 1 3/4"8/16 DP INV CL5 13
94/70009SHAFT 27T 1 3/4" 16/32 8" Long1 3/4"16/32 DP INV CL5 27
94/70011SHAFT 16T 35mm 2MOD 8" Long 35 mm2 MODULE INV 16
94/700113SHAFT 20T 1 3/4" 12/24 8" Long1 3/4"12/24 DP 20
94/700114SHAFT 6T W34 X 28 Din 5463 34 mm 6T DIN 5463 METRIC 6
94/70021SHAFT 18T 1.75 MOD Din 5482 35 mm1.75 MODULE 18
94/70032SHAFT 17T 1 1/2" 12/24 8" Long1 1/2"12/24 DP INV CL5 17
94/70033SHAFT 6T 1 3/8" Straight 1 3/8"6B STRAIGHT SAE 6
94/70039SHAFT 16T 1.7" 10/20 8" Long 1.700"10/20 DP INV CL5 16
94/70040SHAFT 16T 2 1/8" 8/16 8" Long2 1/8"8/16 DP INV CL5 16
94/70043SHAFT 23T 1 1/2" 16/32 8" Long1 1/2"16/32 DP INV CL5 23
94/70045SHAFT 24T W50X2 2 MOD Din 548050 mm2 MODULE INV DIN 5480 24
  • Found 28 records
  • 1
  • 2
  • Next
  • Showing results per page